Applying Edge Cap Channel to Vertical Edge Of Panel.

WOOD SUBSTRATES: Use edge cap #2525 on panels 3/4” thick; 7/8” panels use #3858. Place plastic edge over panel’s edge, insert a 5/8” chisel point staple on two or three sides (edge-front-back) 6” on center starting 1/2” from the top. For additional strength, a standard approved PVC adhesive can be applied into channel of edge cap.
NOTE: On slatwall panels, place staple between slots.

EXTRA STRENGTH: Especially for slatwall panel. Use #4925 aluminum edge cap. This reinforced channel is pre-drilled on center. To fasten use screws.

METAL GRIDWALL & SLAT GRID: Use grid adapter #2687. Foam or paper honeycomb panels use a construction grade two sided tape or an approved adhesive. NOTE: Some adhesive are not compatible with “foam”. Consult manufacturer or supplier.

PVC SLATWALL PANELS: For lightweight applications use #3609 plastic edge cap. Heavy duty applications use #5526 aluminum edge cap.

Apply Walls+Forms
CornerForms™
to panel A.

Stand panel up.

Open the CornerForms™ “mouth”, place over edge of panel (we recommend to start at the bottom of the panel).

Strike the CornerForms™ with the palm of hand at the bottom portion and continue by working upwards.

To join “free panel” B to “stationary panel” A.
(This procedure will require assistance)

Maintain the “stationary panel” A in a secure position. Tilt B on one edge so the opposite or joining edge is approximately 6” off the floor. Insert joining edge into CornerForm™ “mouth”. Push downward into “mouth” while your assistant simultaneously strikes the back of the CornerForms™ at the point of the panel B contact. Continue upward as the form snaps over the panel.

NOTE: This procedure is to be used with radius CornerForms™ angles, such as 30, 45, 60, 90, 120, and 135 degrees.

To join “Non-Radius Angles”

• 180 Degree Connector
• T- Connector
• 4- Way Connector
• Y- Connector
• Y- 90 Connector

Place the form on the free panel B first.

Once the form is attached, tilt the panel back so the bottom edge is 6” off the floor. The assistant should guide CornerFormsTM “mouth” over stationary panel’s “A” edge cap. Firmly push or strike the opposite side (at point which form engages with panel) and continue upwards as panels fasten’s together.

• Firmly grip “free panel” #B
• Lift upward and walk panel in the direction to increase (open) the angle of the “free panel”.
• The panel will disengage from the “mouth” of the form.

NOTE: As panel rotates, edgecap may catch main form’s interior ridge. If this situation occurs DO NOT continue because staples may be pulled from panel. To rectify, insert a standard screwdriver at problem point and run the length of the form.